Out of memory in apploach. - Narita International Airport RJAA for FSX/P3D - FORUM
Out of memory in apploach.
- You cannot open a new topic into this forum
- For posting a new topic to the forum Please login first (To Regist , click Here ) Guests cannot post.
Posts tree
-
Out of memory in apploach.
(wci_admin, 2013/10/5 7:38)
-
Re: Out of memory in apploach.
(ca177, 2013/10/5 13:55)
-
Re: Out of memory in apploach.
(wci_admin, 2013/10/5 14:10)
-
Re: Out of memory in apploach.
(wci_admin, 2013/10/6 12:26)
-
Re: Out of memory in apploach.
(YOSSYAN, 2014/2/16 3:54)
-
Re: Out of memory in apploach.
(wci_admin, 2014/2/16 11:15)
-
Re: Out of memory in apploach.
(liketofly, 2015/2/16 14:26)
-
Re: Out of memory in apploach.
(wci_admin, 2015/2/17 2:49)
wci_admin
Posts: 84
Posts: 84
We are searching about the OOM(Out of Memory) error at the approach now.
This happens, while using PMDG. It is known that this trouble will arise only by PMDG.
However, in order that our RJAA may also use a lot of memories, this problem may arise easily.
Investigation takes several weeks.
And a result will be reported.
[note]
*When PMDG is used, it happens.
*There was two reports by 777.
*It may happen also by 737NGX.
*It does not occur to PMDG all users. The trigger is under investigation.
*It will happen easilier at night than daytime. (It is because FSX reads twice as many textures as this. )
*It will happen easily, when a weather engine is used.
*For the moment by other add-on aircraft, there is no report.
*It has not happened on the default aircraft.
This happens, while using PMDG. It is known that this trouble will arise only by PMDG.
However, in order that our RJAA may also use a lot of memories, this problem may arise easily.
Investigation takes several weeks.
And a result will be reported.
[note]
*When PMDG is used, it happens.
*There was two reports by 777.
*It may happen also by 737NGX.
*It does not occur to PMDG all users. The trigger is under investigation.
*It will happen easilier at night than daytime. (It is because FSX reads twice as many textures as this. )
*It will happen easily, when a weather engine is used.
*For the moment by other add-on aircraft, there is no report.
*It has not happened on the default aircraft.
--
Wing Creation Inc. General Admin
http://www.wingcreation.com/
ca177
Posts: 1
Posts: 1
Hi,
This is not primarily an issue of the memory displayed in task manager, it's about VAS. The cause of it has been discussed to death by the community.
NGX and 777 both uses about 700MB of VAS. FSX itself with a default scenery consumes some 2000MB. When the 4GB VAS seal was hit while you load more sceneries, clouds eetc, FSX crash.
How to avoid?
1. Enable DX10 preview mode. With the fixer released, everyone is able to use the nearly bug free dx10.
2. Set TML to 2048 instead of 4096.
3. Disable the sceneries that you are not flying to, especially photo sceneries.
As a developer, you can optimize your texture size.
Ironically, how many of those complaining about OOM with the 777 actually read the PMDG introduction manual that has tips to avoid OOM?
Thanks,
Zicheng
This is not primarily an issue of the memory displayed in task manager, it's about VAS. The cause of it has been discussed to death by the community.
NGX and 777 both uses about 700MB of VAS. FSX itself with a default scenery consumes some 2000MB. When the 4GB VAS seal was hit while you load more sceneries, clouds eetc, FSX crash.
How to avoid?
1. Enable DX10 preview mode. With the fixer released, everyone is able to use the nearly bug free dx10.
2. Set TML to 2048 instead of 4096.
3. Disable the sceneries that you are not flying to, especially photo sceneries.
As a developer, you can optimize your texture size.
Ironically, how many of those complaining about OOM with the 777 actually read the PMDG introduction manual that has tips to avoid OOM?
Thanks,
Zicheng
wci_admin
Posts: 84
Posts: 84
>ca177
Thank you for the suggestion.
Thank you for the suggestion.
--
Wing Creation Inc. General Admin
http://www.wingcreation.com/
wci_admin
Posts: 84
Posts: 84
Please try "Lite_Textures_Pack."
http://www.wingcreation.com/modules/information/index.php?page=article&storyid=15
http://www.wingcreation.com/modules/information/index.php?page=article&storyid=15
YOSSYAN
Posts: 1
Posts: 1
>1. Enable DX10 preview mode. With the fixer released, everyone is able to use the nearly bug free dx10.
It seems to that night texture is not compatible with DX10.
I checked DX10 preview mode and go to RJAA at night, I found collapsed texture in there,plz check it out. Do you have any plans for this problem?
It seems to that night texture is not compatible with DX10.
I checked DX10 preview mode and go to RJAA at night, I found collapsed texture in there,plz check it out. Do you have any plans for this problem?
wci_admin
Posts: 84
Posts: 84
Our product does not support DX10.
We do not have a schedule to react to it issue.
Thanks.
We do not have a schedule to react to it issue.
Thanks.
--
Wing Creation Inc. General Admin
http://www.wingcreation.com/
liketofly
Posts: 1
Posts: 1
Hi,
Quote:
Unfortunately I don't see this patch in my SimMarket account.
Any Suggestions?
regards
Oberwinkler Richard
Quote:
wci_admin wrotes:
Please try "Lite_Textures_Pack."
http://www.wingcreation.com/modules/information/index.php?page=article&storyid=15
Unfortunately I don't see this patch in my SimMarket account.
Any Suggestions?
regards
Oberwinkler Richard
Previous post
-
Next post
|
Parent
-
No child
|
Posted on 2015/2/17 2:49
wci_admin
Posts: 84
Posts: 84
It seems that the package is removed from an simMarket's installer.
That was set in download page, so please get it from there.
That was set in download page, so please get it from there.